Instructions / Assembly

A
SSEMBLY
1 Assembling the Vertical Pole to the Front Half of Lower
Section
Stack the Vertical Pole (J) into the short metal rod at the base of the
Front Half of Lower Section (G) with the tapered end upwards. Secure
with built in locking pin. Insert the free end of a hook attached to the
metal frame on the Front Half of Lower Section (G) into the matching
hole on the side of the Vertical Pole (J).
2 Assembling the Front Half of Lower Section to the Back
Half of Lower Section
Align the Front Half of Lower Section (G) with the Back Half of Lower
Section (H) then insert the connecting rods into the matching holes.
3 Assembling the Motor Vertical Pole
Stack the Motor Vertical Pole (I) onto the Vertical Pole (J). Secure with
built in locking pin.
4 Assembling the Front Half of Middle Section to the Lower
Section and connecting the Motor Arm
Find the Horizontal Metal Bar (K). This Bar is used to stabilize the Middle
Section and Lower Section of the Pumpkin. Insert (K) thru the matching
holes on the upper rim of Lower Section and the holes on the lower rim of
the Front Half of Middle Section (E) and one hole in the pole of the Motor
and Vertical Pole then lock at the end with the Cotter Pin (L). Connect the
plastic motor arm to the hook on the left inside of the Front Half of Middle
Section then secure with Cotter Pin.
5 Assembling the Head to the Front Half of Middle Section
Insert the small vertical connecting pole located at the base of the Head
Top Section (B) onto the top of the Motor Vertical Pole (I) then secure with
built in locking pin. Insert the free end of long metal connecting bar
attached to the Head Top Section (B) into matching tube on the right
inside of the Front Half of Middle Section (E) then lock with the Cotter
Pin (L).
6 Assembling the Back Half of Middle Section to the Front Half
of Middle Section
Align the Back Half of Middle Section (F) with the Front Half of Middle
Section (E) then insert the connecting rods into the matching holes.
7 Assembling the Hat and Hands
Insert the connecting rods on the Hands (C, D) into the matching holes
on the sides of the Front Half of Middle Section (E). Insert the connecting
rods on the bottom of the Hat (A) into the holes on the top of the Head
Top Section (B). Fasten all parts together at the connecting loops with
the Plastic Ties (N).
8 Assembling the Ground Stakes
Place the Ground Stakes (M) over the metal frame at the base of the
Lower Section of Pumpkin at four points then into the Ground.