Instructions / Assembly

SSEMBLY

1 Assembling the Lower Section to the Base Stand

Insert the connecting rods on the bottom of the Lower Section (A) into

the connecting holes on the middle of the Base Stand (E) then fasten

together at the connecting loops with the Bolt & WingNuts (F).

2 Assembling the Middle Section to the Lower Section

Insert the connecting rods on the bottom of the Middle Section (B) into

the connecting holes on the top of the Lower Section (A) then fasten

together at the connecting loops with the Bolt & WingNuts (F).

3 Assembling the Upper Section to the Middle Section

Insert the connecting rods on the bottom of the Upper Section (C) into

the connecting holes on the top of the Middle Section (B) then fasten

together at the connecting loops with the Bolt & WingNuts (F).

4 Assembling the Light String & Branches

Insert the connecting rod at the end of each of the Branches (D) into the

connecting holes on the Upper Section of the Tree (C).

5 Connecting the Light Strings

Connect the lighting string by inserting the pins on one set into the

receptacle holes of another lighting string then press together tightly.

6 Assembling the Branches

Unravel the Branches and let them fall naturally downward. Use the

diagram of the finished Tree on this Assembly Sheet as a reference to

best place the Branches on the Tree.

7 Assembling the Plug

Push two pins of lighting set near the base of the Tree into the end of

adaptor then screw down tightly until secure.

8 Assembling the Ground Stakes

Insert Ground Stakes (G) over the metal frame at 4 corners of the Base

Stand (per diagram below) then firmly into the ground.