Owner Manual

How to set the control box
1,How to turn on/o ffand how to start?
Press the switch button on the side of the thermostat to start
the machine.
Press once to count down and press again to reset.
2,How to set the temperature/time?
Press once to set the temperature, press twice to set the time
and press again to exit. ( It will automatically exit the
temperature/time setup state in case of on operation within 5s.)
3,How to set the temperature/time to increase or decrease?
Set the temperature/time increase
Set the temperature/time decrease
4,How to change the temperature unit from ℃ to ℉?
In the power-on state, press “+” and “-” at the same time
to change the temperature unit between ℃ and ℉.
5,How to set auto shutdown time?
Press and hold for 5s, to set the auto shutdown time.
(The factory default is 60min and the range is from 10min to
120min)
6, How to do temperature correction?
Press and hold for 5sec to enter the tempertature correction
setting. (Range 30℃ (86℉). initial value is 0)
7, How to turn on/off the beep sound?
In the shutdown state, press “-” to turn o ffthe sound and OFF
is shutdown; Press again to turn on the sound and shown.
8, Tips:The max, set temperature of this machine is 210℃(410 ) ℉
and the longest time is 999sec.
(If the machine temperature and strength temperature do not
conform to the situation )
Control box introduction：
1, Attachment for T-shirts
The machine is defaulted to T-shirt mode, The default temperature
is 200℃（392℉） while the timer is set to 60s.
Thank you for purchasing our product, We appreciate your business. It is a
multi-purpose heat press machine with which
attachment to make it compatible with different tasks.
you can apply it on T-shirts,
caps, mugs and Aluminum Bottle. however, It does require different
Heat Press Machine Users' Guide
The whole attachment easily slides in/out , after taking out the
previous attachment, insert the attachment for caps/hat and slide it in,
fix it with screws.
This attachment do not need to install and just need to plug in the
control box, then it will work, If you want to replace the cup, looser
the clamp and replace the cup.
2,Attachment for caps/hats installation.
3.Attachment for cups and cylindrical objects installation