Owner Manual

Note: Operating water pressure and maximum water pressure are obtained in the
experimental test environment , which may be different from the actual
use environment.
MADE IN CHINA
17
No detergent.
Detergent suction tube
not properly connected
to the machine.
Check connection.
Filter on detergent
suction tube is clogged.
Run warm water through filter to remove
debris.
Damaged or clogged
detergent suction tube.
Remove obstruction or replace detergent
suction tube.
Spray wand is in high
pressure position.
Turn spray wand tip to low pressure position.
Discharge nozzle is
obstructed.
Blow out or remove debris with fine needle.
Garden hose
connection leaks.
Loose fittings.
Tighten fittings.
Spray wand leaks.
Spray wand not
properly attached.
Insert the spray wand into the trigger gun.
Carefully press in against the spring tension
and twist into the locked position.
Broken O-ring or plastic
insert.
Call Customer Support
Pump is noisy.
Pump is sucking air.
Check that hoses and fittings are air tight.
Turn off machine and purge pump by
squeezing trigger gun until a steady flow of
water emerges through the nozzle.
Water leaks from pump
(up to 10 drops per
minute is permissible).
Loose fittings.
Check that all fittings are tight.
Water seals are
damaged or worn.
Customer Support