Owner Manual

TROUBLESHOOTING
CAUTION
Disconnect the machine from the
power source before making any
repair.
Symptom
Cause
Solution
Motor will not start
On/Off switch is in the
“OFF” position.
Turn switch to the “ON” position
Power cord is not
plugged in.
Plug in power cord.
Electrical outlet does
not supply adequate
power.
Try a different outlet.
Tripped circuit breaker.
Switch off pressure washer. The reset
comes automatically
once the temperature of the unit drops.
Unit does not reach
high pressure.
Diameter of garden
hose is too small.
Replace with a suitable garden hose.
Water supply is
restricted.
Check garden hose for kinks, leaks and
blockage.
Not enough inlet water
supply.
Open water source full force.
Water inlet filter is
clogged.
Remove filter and rinse out in warm water.
Spray wand is on low
pressure position.
Draw spray wand to high pressure position.
Output pressure varies
high and low.
Not enough inlet water
supply.
Turn water on full force. Check garden hose
for kinks, leaks or blockage.
Pump is sucking air.
Check that hoses and fittings are air tight.
Turn off machine and purge pump by
squeezing trigger gun until a steady flow of
water emerges through the nozzle.
Water inlet filter is
clogged.
Remove filter and rinse out in warm water.
Lance is obstructed.
Blow out or remove debris with a fine
needle.
Calcified gun, hose or
spray wand.
Run distilled vinegar through detergent
suction tube.