Use and Care Manual

WARNING:

DO NOT attempt to operate the heater until you have

read and understood all precautions. Failure to do so

can result in serious personal injury, death, and property

damage.

WARNING:

FOR YOUR SAFETY

DO NOT touch or move heater for at least 45 minutes

after use. Allow emitter and dome to cool before

touching.

WARNING:

FOR YOU SAFETY

If at any time you are unable to light burner and smell

gas, wait 5 minutes to allow gas to dissipate before

attempting to light heater. If after 1 minute, you are

unable to light burner, wait 5 minutes and allow

ammable vapors to dissipate before attempting to

light heater again.

BEFORE TURNING GAS SUPPLY ON

Your heater was designed and approved for OUTDOOR USE ONLY. Do Not use it inside a building, or any other

enclosed area. Make sure surrounding areas are free of combustible materials, gasoline, and other ammable

vapors or liquids. Ensure that there is no obstruction to air ventilation. Be sure all gas connections are tight and

there are no leaks. Be sure that access panels are clear of debris. Be sure any component removed during

assembly or servicing is replaced and fastened prior to starting.

BEFORE LIGHTING

Heater should be thoroughly inspected before each use, and by a qualied service person at least annually.

If relighting a hot heater, always wait at least 5mins. This heater is tested for quality assurance. Ignition attempts

should succeed 8 out of 10 attempts.

LIGHTING INSTRUCTIONS

1. Turn the control knob to “OFF” position

2. Open base assembly door

3. Turn the gas supply on by connecting the propane cylinder to the regulator inlet. Check for leaks by applying

soap solution to cylinder and regulator connection.

4. Push in gas control knobs lightly and turn counterclockwise to “ON” this will light the burner. If needed, keep

depressing and turn control knob counterclockwise until the burner lights.

5. Keep the control knob depressed for at least 30 seconds after lighting the burner. After 30 seconds release

the control knob.

6. If burner does not stay lit, repeat steps 4 to 5

7. When burner is lit, turn gas control knob counterclockwise to desired higher setting.

8. Close the base assembly door.

Note: The ame pattern at the emitter grid should be visually checked whenever heater is operated. Normally

the burner ame is blue, but a little yellow ame is acceptable. If ames extend beyond the emitter grid or there

are black spots that have accumulated on the emitter grid or reector, immediately turn off the heater. The

heater should not be operated again until it has been serviced and repaired by a qualied gas technician.

Operation