Use and Care Manual

5
STEP 5
Put the emitter screen on the burner. Use (4) four 3/16”
bolts to connect the emitter screen to the burner.
Tighten the bolts.
STEP 6
Put the guard on the burner through the emitter
screen. Put the ends of the guard into the holes of the
burner.
STEP 7
Put (3) three washers on each pins of the 60mm
length.
STEP 8
Put the reector through the pins and on the washers.
STEP 9
Fasten the reector with (3) three M6 castle nuts.