Use and Care Manual

Assembly

WARNING:

Proper assembly is the responsibility of the installer. Place the heater in a well-ventilated space and do not place in

a building, garage, or any other enclosed area.

An appliance must be installed with shelter no more inclusive than:

1. With walls on all sides, but with no overhead cover.

2. Within a partial enclosure which includes an overhead cover and no more than two side walls. These side

walls may be parallel, as in a breezeway, or at right angles to each other.

3. Within a partial enclosure which includes an overhead cover and three side walls, as long as 30% or more of

the horizontal periphery of the enclosure of permanently open.

STEP 1

Use (4) four M6 X 15mm bolts to x the tank housing

to the base & cast iron. Tighten the bolts as shown

above.

STEP 2

Put the burner on the tank housing then x them with

(4) four 3/16” bolts.

STEP 3

Fix the regulator to the tank housing with the M5 X

10mm bolt & M5 nut.

STEP 4

Fix (3) three pins of 60mm length to the emitter screen

with (3) three ange nuts, then tighten them.