Use and Care Manual

d. Any guard or other protective device removed for servicing the heater must be replaced prior to

operation the heater

e. Installation and repair should be done by a qualied service person. The heater should be inspected

before use and cleaning may be required at least once a year or as necessary. It is imperative that

control compartment burner and circulation air passageways of the heater be kept clean.

• Keep the appliance area clear of combustible materials such as gasoline and other ammable vapors and

liquids.

• DO NOT obstruct the ow of combustion and ventilation air reector.

• Keep the ventilation opening of the cylinder enclosure clear of any obstructions.

NOTE: PLEASE READ THE FOLLOWING SAFETY RULES.

The valve outlet must be maintained in good condition. All gas connections should be checked for leaks utilizing

a soap solution. Never use a ame to test for leaks. A leak test should be performed with soapy water whenever

connecting a new cylinder. Never use a match to test for leaks. If disassembly is required, a leak test should be

performed with soapy water upon reassembly. The heater is designed to operate with a standard 1 lbs. propane

cylinder with approved cylinder connection. The gas manifold supply pressure must be regulated at 11 inches

water column utilizing an approved regulator. The minimum inlet gas supply pressure for the purpose of input

adjustment is 8 inches water column. The maximum inlet gas supply pressure 13 inches water column.

1. The cylinder supply system must be arranged for vapor withdrawal.

2. The cylinder used must include a collar to protect the cylinder valve only cylinders marked “propane” must

be used.

WARNING:

• Do not store a spare LP-gas cylinder under or

near this appliance.

• Never ll the cylinder beyond 80% full.

WARNING:

Save these instructions! Retain in a safe place for

future reference.

WARNING:

LP-gas supply cylinder to be used must be:

1. Constructed and marked in accordance with

the specications for LP-gas cylinders of the

U.S. Department of Transportation (DOT); or

the standard for cylinders , spheres, and tubes

for transportation of dangerous goods and

commission, CAN/CSA-B339;

2. Provided with a listed overlling prevention

device;

3. Provided with a cylinder connection device

compatible with the connection for the

appliance.