Instructions / Assembly
-8-
WARNING:
• Do not sit or stand on this re pit table.
• Keep children away during assembly, as this item contains small parts which can be swallowed by
children.
• Do not use indoors or inside any enclosure.
• Retain the assembly instructions for future reference.
• Installer- Please leave these instructions with the owner.
• Do not store a spare LP-gas cylinder under or near this appliance;
• Never ll the cylinder beyond 80 percent full;
• Place the dust cap on the cylinder valve outlet whenever the cylinder is not in use. Only install the type of
dust cap on the cylinder valve that is provided with the cylinder valve. Other type of caps or plugs may
result in leakage of propane.
ATTENTION: THIS PRODUCT IS NOT FOR COMMERCIAL USE INTENDED FOR RESIDENTIAL USE ONLY.
12. Use this re pit only with a vapor withdrawal supply system. See Chapter 5 of the standard for storage and
handling of liqueed petroleum gas, ANSI/NFPA 58. Your local library or re department should have this
book. Storage of an appliance indoors is permissible only if the cylinder is disconnected and removed from
the appliance. A cylinder must be stored outdoors in a well-ventilated area out of reach of children. A
disconnected cylinder must have all dust caps tightly installed and must not be stored in a building, garage
or any other enclosed area. The maximum inlet gas supply pressure: 250 psi. The minimum inlet gas supply
pressure: 5 psi. The minimum hourly rate of 10000 Btu is required input rating for a re pit for automatic
operation at rating less than full input rating. The pressure regulator and hose supplied with the appliance
must be used. The installation must conrm with local codes or in the absence of local codes, with national
fuel gas code, ANSI Z223.1/NFPA54, natural gas and propane Installation Code, CSA 8149.1, or propane
storage and handling code, 8149.2. A dented, rusted or damaged propane cylinder may be hazardous
and should be checked by your cylinder supplier. Never use a propane cylinder with a damaged valve
connection. The propane cylinder must be constructed and marked in accordance with the specications
for LP gas cylinders of the U.S. Department of Transportation(DOT) or the standard for cylinders, spheres
and tubes for transportation of dangerous goods and commission, CAN/CSA-B339. The cylinder must have
a listed overlling prevention device. The cylinder must have a connection device compatible with the
connection for the appliance. The cylinder used must include a collar to protect the cylinder valve. Never
connect an unregulated propane cylinder to the appliance.