Instructions / Assembly

-6-

4. Disassemble the washers and screws located in the four corners of the burner assembly (B), lower the burner

assembly (B) down into the table top (D). Align the holes in the four corners of the burner assembly (B) with

the holes in the table top (D) and assemble the burner assembly (B) to the table top (D) using the four screws

and washers.

5. Attach the table top (D) to the previously assembled side panels. Align the holes in the table top (D) with

the holes at the top of the previously assembled side panels. Insert M8 X 16 bolts through MB washer and

through the aligned holes. Tighten with a wrench. DO NOT OVER TIGHTEN as you will need to adjust the holes

to ensure proper alignment.

Note: The control box on the burner assembly should face towards the door panel with door.

6. Pour the re glass around the burner.

7. Put the table top insert (A) over the burner assembly when the re pit is NOT in use or after use, when the re

pit has cooled COMPLETELY.