Instructions / Assembly
-11-
WHEN FIRE PIT IS ON
Burner will display tongues of blue and yellow ame. These ames should not be yellow or produce thick black
smoke, which would indicate an obstruction of airow through the burner. The ame should be blue with straight
yellow tops. If excessive yellow ame is detected, turn off the re pit and consult the troubleshooting section of
this manual.
RE-LIGHTING
1. Turn control knob to “OFF”.
2. Repeat the relighting steps provided in this manual.
SHUT DOWN
1. To extinguish burner depress control knob and continue to turn it clockwise to “OFF”.
2. Turn cylinder valve clockwise to “OFF” and disconnect the regulator when the re pit is not in use.
WARNING:
FOR YOUR SAFETY
Fire pit will be hot after use. Handle with extreme care.
WARNING:
FOR YOUR SAFETY
Be careful when attempting to manually ignite this re pit. Holding in the control knob for more than 10 seconds
before igniting the gas will cause a ball of ame upon ignition.
WARNING:
FOR YOUR SAFETY
Do not touch or move the re pit for at least 45 minutes after use. The re pit is hot to the touch. Allow the re
pit to cool before touching.
Care And Maintenance
To enjoy years of outstanding performance from your re pit, make sure you perform the following maintenance
activities on a regular basis, keep the exterior surfaces clean:
1. Use warm soapy water for cleaning. Never use ammable or corrosive cleaning agents.
2. While cleaning your unit, be sure to keep the area around the burner dry at all times. Do not submerge the
control valve assembly. If the gas control is submerged in water, do NOT use it. It must be replaced.
a. Keep the appliance area clear and free from combustible materials, gasoline, and other ammable
vapors and liquids.
b. Do not obstruct the ow of combustion and ventilation air.
c. Keep the ventilation opening of the cylinder enclosure free and clear from debris.
3. Air ow must be unobstructed. Keep controls, burner, and circulating air passage ways clean. Signs of
possible blockage include:
• Gas odor with extreme yellow tipping of ame.
• Fire pit does NOT reach the desired temperature.
• Fire pit glow is excessively uneven.
• Fire pit makes popping noises.
• Spiders and insects can nest in burner or orices. This dangerous condition can damage the re pit and
render it unsafe for use. Clean the burner holes by using a heavy-duty pipe cleaner. Compressed air
may help clear away smaller particles.
• Carbon deposits may create a re hazard. Clean the burner with warm soapy water if any carbon
deposits develop.
Note: In a salt-air environment (such as near an ocean), corrosion occurs more quickly than normal. Frequently
check for corroded areas and repair them promptly.