Instructions / Assembly

-10-
DANGER:
CARBON MONOXIDE HAZARD
For outdoor use only. Never use inside a house, or
other unventilated or enclosed area. This re pit
consumes air (oxygen). To avoid endangering your
life, do not use in an unventilated or enclosed area.
WARNING:
VERY HOT WHILE IN OPERATION
Never lean over the re pit while in use. Do not touch
surfaces while the re pit is in operation. Wait until the
re pit has completely cooled down after use. Failure
to comply with these instructions may result in serious
bodily injury.
Caution: Do not attempt to operate until you have read and understand all General Safety Information in this
manual and all assembly is complete and leak checks have been performed.
BEFORE TURNING GAS SUPPLY ON
1. Your re pit was designed and approved for outdoor use only. Do NOT use it inside a building, garage, or
any other enclosed area.
2. Make sure surrounding areas are free of combustible materials, gasoline, and other ammable vapors or
liquids.
3. Ensure that there is no obstruction to air ventilation. Be sure all gas connections are tight and there are no
leaks.
4. Be sure the cylinder cover is clear of debris. Be sure any component removed during assembly or servicing is
replaced and fastened prior to starting.
BEFORE LIGHTING
1. Fire pit should be thoroughly inspected before each use, and by a qualied service person at least annually.
If relighting a hot re pit, always wait at least 5 minutes.
2. Inspect the hose assembly for evidence of excessive abrasion, cuts, or wear. Suspected areas should be leak
tested. If the hose leaks, it must be replaced prior to operation. Only use the replacement hose assembly
specied by manufacturer. The burner must be replaced prior to the appliance being put into operation if
it is evident that the burner is damaged. The replacement burner should be specied by the manufacturer.
LIGHTING
1. Make sure the control knob is in the “OFF” position.
2. Fully open LP cylinder valve.
Note: For initial start or after any cylinder change, hold the control knob in for 2 minutes to purge air from the gas
lines before proceeding.
3. Push in gas control knob, turn counterclockwise to “LOW”, and press the red ignitor button to light the re
pit. If needed, keep the control knob depressed and continue pressing the red ignitor button until the re pit
lights (you should hear a clicking sound).
4. After the re pit lights, release the control knob. To increase the ame, turn the control knob counterclockwise
to "HIGH". To decrease the ame, turn the control knob clockwise to “LOW”.
Note: If burner fails to remain lit, all valves should be closed and a waiting period of at least 5 minutes should
pass before attempting to light.
Figure A Figure B Figure C
IGNITOR IGNITOR IGNITOR IGNITOR
P
U
S
H
T
O
T
U
R
N
H
I
G
H
OFF
LOW
H
I
G
H
H
I
G
H
OFF
LOW
P
U
S
H
T
O
T
U
R
N
OFF
LOW
P
U
S
H
T
O
T
U
R
N