Installation Guide

8
This appliance is not intended for use by persons (including children) with
reduced physical, sensory or mental capabilities, or lack of experience and
knowledge, unless they have been given supervision or instruction concerning
use of the appliance by a person responsible for their safety. Children should be
supervised to ensure that they do not play with the appliance.
When moving or relocating the air conditioner,consult experienced service
technicians for disconnection and reinstallation of the unit.
Do not place any other electrical products or household belongings under the
unit.Condensation dripping from the unit might get them wet,and may cause
damage or malfunction of your property.
To keep ventilation openings clear of obstruction.
The appliance shall be stored in a well-ventilated area where the room size
corresponds to the room area as specified for operation.
The appliance shall be stored in a room without continuously operating open
flames (for example:an operating gas appliance )and ignition sources(for
example operating electric heater).
Any person who is involved with working on or breaking into a refrigerant circuit
should hold a current valid certificate from an industry-accredited assessment
authority, which authorises their competence to handle refrigerants safely in
accordance with an industry recognised assessment specification.
Servicing shall only be performed as recommended by the equipment
manufacturer.
Maintenance and repair requiring the assistance of other skilled personnel shall
be carried out by the person competent in the use of flammable refrigerants.
The pipe-work shall be complianced with national gas regulations.
The maximum refrigerant charge amount is 0.45kg.
The installation of pipe-work shall be kept to minimum.
If the refrigerant is flammable the air conditioning equipment shall have red,
Pantone® Matching System (PMS) #185 marked service ports, pipes, hoses, and
other devices through which the refrigerant is serviced. This colour shall be
present at all service ports and where service puncturing or otherwise creating
an opening from the refrigerant circuit to the atmosphere might be expected
(e.g., process tubes). The colour mark shall extend at least 25 mm (1 inch) from
the refrigerant servicing point and shall be replaced if removed