Installation Guide

15
Instructions of key operation of the high-quality remote control are as
follows:
1.Power: Press+++ the key to turn on or turn off the machine.
2.Timer: press+++ the key to set timing.
3. Down: press+++the key to reduce temperature and timing set value.
4. Mode: press+++ the key to switch between cooling, fan, dehumidifying
mode.
5. Up: press+++ the key to increase temperature and timing set value.
6. Fan: press+++ the key to select high, low wind speed.
7. Sleep Mode: Press +++the key to turn on the sleep mode.
IV. Protection function
3.1、Frost Protection Function:
In cooling, dehumidifying or economic power saving mode, if the
temperature of the exhaust pipe is too low, the machine will automatically
enter protection status; if the temperature of the exhaust pipe rises to a
certain temperature, it can automatically revert to normal operation.
3.2、Overflow Protection Function:
When water in the water pan exceeds the warning level, the machine will
automatically sound an alarm, and the "FULL" indicator light will flash. At this
point, you need to move the drainage pipe connecting the machine or the
water outlet to sewer or other drainage area to empty the water (details see
Drainage Instructions at the end of this chapter). After the water is emptied,
the machine will automatically return to the original state.
3.3、Protection Function of the Compressor
To increase the service life of the compressor, it has a 3-minute delay booting
protection function after the compressor is turned off.
V.Installation and adjustment
1.Installation：
Warning: before using the mobile air conditioning, keep it upright for at least
two hours.
The air conditioning can be easily moved in the room. In the moving process,
ensure that the air conditioning is in the upright position and the air
conditioning should be placed on a flat surface. Do not install and use the air
conditioning in the bathroom or other humid environments.
1.1 Install the heat pipe assembly （as shown in Fig.1）