User Manual

4. Operation instruction as a wireless strobe siren - CONFIGURATION
4.1 Add 106F to 106AW
1) Put the plug of transmitter(106F) to the siren outlet of alarm host. If work with the wired alarm system, you need cut off
the terminal of the 106F plug, then connect the red wire to wired alarm system positive pole, connect the black wire to
negative pole.
2) After 106AW is power on, and battery switch to ON position, it enter the normal working state, press 106W “learn”
button 1 second, 106AW beep once, flashing lights on and then enter the learning mode.
3) Press now SOS button on the Homcloud Alarm panel, then the transmitter led lights on, and you will hear 106AW beep
twice, means add 106F successfully.
4) After alarm host is alarming, 106F will send a signal to 106AW, and 106AW will alarm with sound and flashing light.
5) After the alarm host is disarmed, 106F will send the disarming signal to 106AW, 106AW stop alarming.
6) Press 106AW “learn” button 1 second or wait 20seconds to exit the learning mode.
4.2 Delete the transmitter
Press “Learn” button 1 second, 106AW beep once to enter learning mode , then press and hold “Learn” button 5 seconds,
106AW sound beep six times, light off, and then release “Learn” button, means delete the transmitter.
4.3 Restore factory setting
Disconnect the power of 106AW, turn off the battery switch, then press and hold the “Learn” button while power-on.
106AW will respond with beep six times, then release the “Learn” button, restore factory setting successfully.
Remark: This feature will restore all settings to factory default, all transmitters will be deleted.