Safety Data Sheets (SDS)

4096 AEROSOL WALL TEXTURE WATER BASED - ORANGE PEEL - COLOR
CHANGING
Product name
9
Product code
Date of issue
Version
00384862
24 July 2020
Section 6. Accidental release measures
Stop leak if without risk. Move containers from spill area. Use spark-proof tools and
explosion-proof equipment. Approach release from upwind. Prevent entry into sewers,
water courses, basements or confined areas. Wash spillages into an effluent treatment
plant or proceed as follows. Contain and collect spillage with non-combustible,
absorbent material e.g. sand, earth, vermiculite or diatomaceous earth and place in
container for disposal according to local regulations (see Section 13). Dispose of via a
licensed waste disposal contractor. Contaminated absorbent material may pose the
same hazard as the spilled product. Note: see Section 1 for emergency contact
information and Section 13 for waste disposal.
Large spill
:
Section 7. Handling and storage
Advice on general
occupational hygiene
Conditions for safe storage,
including any
incompatibilities
Eating, drinking and smoking should be prohibited in areas where this material is
handled, stored and processed. Workers should wash hands and face before eating,
drinking and smoking. Remove contaminated clothing and protective equipment before
entering eating areas. See also Section 8 for additional information on hygiene
measures.
Do not store below the following temperature: 5°C (41°F). Store in accordance with
local regulations. Store away from direct sunlight in a dry, cool and well-ventilated area,
away from incompatible materials (see Section 10) and food and drink. Protect from
sunlight. Store locked up. Eliminate all ignition sources. Use appropriate containment
to avoid environmental contamination.
:
:
Protective measures
Put on appropriate personal protective equipment (see Section 8). Pressurized
container: protect from sunlight and do not expose to temperatures exceeding 50°C. Do
not pierce or burn, even after use. Avoid exposure - obtain special instructions before
use. Do not handle until all safety precautions have been read and understood. Do not
get in eyes or on skin or clothing. Do not ingest. Avoid breathing gas. Avoid breathing
vapor or mist. Use only with adequate ventilation. Wear appropriate respirator when
ventilation is inadequate. Store and use away from heat, sparks, open flame or any
other ignition source. Use explosion-proof electrical (ventilating, lighting and material
handling) equipment. Use only non-sparking tools. Empty containers retain product
residue and can be hazardous.
:
Precautions for safe handling
Special precautions
:
If this material is part of a multiple component system, read the Safety Data Sheet(s) for
the other component or components before blending as the resulting mixture may have
the hazards of all of its parts.
Section 8. Exposure controls/personal protection
Control parameters
Occupational exposure limits
United States
Page: 5/14