Installation Instructions

3
Metal frame clips installation diagram:
D. Installation to Concrete/Masonry Walls
1. Install wood furring strips, not exceeding 16" o.c.
2. Apply Design Wall panels following "Installation to Wood Frame Walls
E. Installation to Finished Walls:
1. Apply wall panels following "Installation to Wood Frame Walls," putting adhesive to back of wall panels
instead of on wood framing in 3/8" beads 16" o.c. and at perimeter, holding adhesive back 3/4" from
edge. Panels must be aligned such that panel edges would fall on framing behind finished wall. Panels
must be fastened to framing behind finished wall.
Cutting Panels:
Cuts can be easily made by either hand or power sawing. Always use a medium to fine tooth saw
whether hand or power. If cutting with a hand saw, cut from finished side of panel; if using a portable
power saw, rotary or saber, cut from back of panel. Small cuts (electric boxes, etc.) can be readily made
with several passes of a sharp utility knife.