Installation Guide

1
Locate the area of the door to install the bypass floor guide.
Mark the dotted guides on
t
he location of the inside door.
Put the hardware together.
Install the bypass floor guide on to the area marked.
Adust the bypass floor guide.
Have the outside door set on the track.
INSTALLATION OF THE ADJUSTABLE FLOOR GUIDE FOR BENT HANGERS
Locate the area where the two doors
overlap when its fully closed. Have the
floor guide to be installed on the inside
door.(Inside door is tinted on the diagram.)
You can now put the outside door on the
track and fit the tip in to the doors groove
while following step 12.
Now fasten the screws
tightly so the adjusment
does not move out of
place.
on the in
dicated area
of the first and second
hole.
Inside Door
1
0
www.homacer.com
6
YOUR INSTALLATION IS COMPLETE!
2
Repeat the same step for the doors with bent hanger
as Step 7. You can use this method to slip the groove
of the door into the tip of the floor guide.
Repeat the same step for the bent
hanger design.
Just like step 5.
Straight Design HangerClassic Design Hanger
Please follow the diagram above on how the hex bolt,
washers and nut should be installed on the door and
hangers. Do not install them any other way since it
may interfere with the function of the sliding system.