t User guide

Publication

88PN3005

Please Contact

Technical Support At 203

736

8890 With Any Additional Questions

Please Be Prepared To Provide Pump Serial Number During Call

Page

1 of 1

•

Screw nipple assembly into motor cap using the

fittings shown in the photo at the right.

• Always apply teflon tape or water-proof thread

sealent to prevent leaks

• Place air bleed valve in the large hole in the metal

bracket.

• Screw the two bolts on the motor cap through the

holes on the “arms” of the bracket. Leave the

bracket slightly loose and moveable

• REMEMBER: The bolts on a motor cap are

frequently loctited and may need to be heated to be

removed.

• Screw the air bleed valve into the top fitting of the

nipple assembly until the bottom surface of the

valve is flush with the bracket.

• Align bolt holes in valve with bolt holes in bracket

and screw bolts completely through valve.

• Put flat-sided washers and nuts on the end of the 5

bolts and tighten all loose nuts and bolts.

Installing Air Bleed

Valve and Bracket

PAGE 1
Installing Air Bleed Valve and Bracket • Screw nipple assembly into motor cap using the fittings shown in the photo at the right. • Always apply teflon tape or water-proof thread sealent to prevent leaks • Place air bleed valve in the large hole in the metal bracket. • Screw the two bolts on the motor cap through the holes on the “arms” of the bracket. Leave the bracket slightly loose and moveable • REMEMBER: The bolts on a motor cap are frequently loctited and may need to be heated to be removed.