Installation Of HOMA GRP Pump On 2,5 Myers Rail Systems User guide

Publication

88PN3030A

Please Contact

Technical Support

At 203

736

8890 With Any Additional Questions

Please Be Prepared To Provide Pump Serial Number During Call

Page

1 of 2

Conversion Kit For Installation of HOMA

GRP Pumps On 2½” Myers Rail

Systems

Use existing Myers hardware to connect the HOMA pump to the Myers rail system

following the procedure below.

•

Thread the 2” X 2 ½” bushing fully onto the discharge of the new HOMA pump after

applying red thread locking compound.

• After applying red thread locking compound, thread the flange threads onto the male

threads of the bushing. Tighten fully until two of the flange bolt holes are in a

horizontal position.

• Align and fasten the flange to the Myers bracket using existing bolts and new gasket

provided. Tighten the bolts equally. If existing bolts are damaged, obtain qty (4) new

5/8”-11 x 1 1/2”bolts.

• Remove the pump handle from the HOMA pump and rotate the handle 180

so that

the high side of the handle is on the same side as the pump discharge connection,

and reattach.

• Thread locking cap onto the threaded portion of the support column. Thread

together

loosely as the cap will be used for final adjustment.

• Slide the support column down through the upper bracket of the Myers rail system

so that the notch is over the handle of the HOMA pump.

PAGE 1
Conversion Kit For Installation of HOMA GRP Pumps On 2½” Myers Rail Systems Use existing Myers hardware to connect the HOMA pump to the Myers rail system following the procedure below. • Thread the 2” X 2 ½” bushing fully onto the discharge of the new HOMA pump after applying red thread locking compound. • After applying red thread locking compound, thread the flange threads onto the male threads of the bushing. Tighten fully until two of the flange bolt holes are in a horizontal position.
PAGE 2
Publication 88PN3030A • Insert the clevis pin through the hole in the support column and under the handle. • Secure the clevis pin with the cotter pin. Do not forget to bend over the ends of the cotter pin to keep it from falling out. • Tighten the locking cap with a wrench taking up any slack. • Tighten the two existing locking screws in the Myers upper bracket against the support column. This will ensure proper support of the pump.