Users Manual

Integration instructions for host product manufacturers according to KDB 996369 D03 OEM Manual v01
2.2 List of applicable FCC rules
CFR 47 FCC PART 15 SUBPART C has been investigated. It is applicable to the modular transmitter
2.3 Specific operational use conditions
This module is stand-alone modular. If the end product will involve the Multiple simultaneously
transmitting condition or different operational conditions for a stand-alone modular transmitter in a host,
host manufacturer have to consult with module manufacturer
for the installation method in end system.
2.4 Limited module procedures
This module is Limited single modular without shielding, host manufacturer have to consult with module
manufacturer for the module limiting conditions when integrate the module in the host. module
manufacturer should reviews detailed test data or host designs prior
to giving the host manufacturer approval.
2.5 Trace antenna designs
Not applicable
2.6 RF exposure considerations
The device has been evaluated to meet general RF exposure requirement. The device can be used in
portable exposure condition without restriction.
2.7 Antennas
This radio transmitter FCC ID:2ALGY-20046 has been approved by Federal Communications
Commission to operate with the antenna types listed below, with the maximum permissible gain
indicated. Antenna types not included in this list that have a gain greater than the maximum gain
indicated for any type listed are strictly prohibited for use with this device.
2.8 Label and compliance information
The final end product must be labeled in a visible area with the following" Contains FCC ID:
2ALGY-20046".
2.9 Information on test modes and additional testing requirements
Host Host manufacturer which install this modular with limit modular approval should perform the test of
radiated emission and spurious emission according to FCC part 15C:15.247 and 15.209 requirement,
only if the test result comply with FCC part 15.247 and 15.209 requirement, then the host can be sold
legally.
2.10 Additional testing, Part 15 Subpart B disclaimer
Host manufacturer is responsible for compliance of the host system with module installed with all other
applicable requirements for the system such as Part 15 B.
Antenna No. Operate frequency
band
Antenna Type Maximum antenna
gain
Bluetooth 2400-2500MHz PCB Antenna 0dBi