ANT+ 2.4G Wireless Heart Rate Monitor Sensor (M/N: HRM) User Manual ver: 1.0 Holux Technology www.holux.
Content Content ....................................................................................................................................................... 1 Heart Rate Monitor (HRM) Sensor ............................................................................................................. 2 Strapping HRM to your chest .............................................................................................................. 2 HRM Spec. ...............................................
Heart Rate Monitor (HRM) Sensor HRM is set to notify users with alarm when the heart rate exceeds or falls behind a specific range of heart rates per minutes. Strapping HRM to your chest Each HRM set contains the heart rate monitor sensor and elastic chest strap. The HRM sensor and chest strap should be worn in the front position as shown. There are two conductive rubbers on the elastic chest strap, slightly moisten them to have better conductivity.
3
HRM Spec. Dimension 63.5X HRM Sensor Memory RAM: 32.2X12.9mm Heart Rate Range: 30-220 beats per minute. 768B ROM: 16KB Flash Wireless Built-in Nordic 2.4GHz wireless Support ANT+ Sport Protocol 1 Mbps on-air date rate GFSK modulation 2.4G ISM band, 1 Mhz frequency resolution, 78 RF channels Up to 0 dBm output power Transmission distance: 6-7m (Max) Battery CR2032 Active voltage: 2-3V Active average power consumption: 3.6mA Sleep average power consumption: 12.
Wireless Link- GPSport 260 The GPSport 260 Pro is using ANT+ to collect and transfer sensor data. The three sport sensors supported are HRM, speed sensor and cadence. Activate Wireless Link Users have to activate the GPSport 260 Pro wireless link before they connect the GPSport 260 Pro with sport sensors. If the wireless link is not yet activated, the setting menu displays “Activate” for selection, otherwise, “Deactivate” is displayed when the device is active.
failure. The GPSport 260 Pro can connect up to 3 sensors of different kinds at a time, namely, one HRM, one Speed sensor, and one Cadence sensor can be connected concurrently. If a sport device is detected, a screen appears as shown.
"FEDERAL COMMUNICATIONS COMMISSION INTERFERENCE STATEMENT This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
