Instructions / Assembly

[phone]
Installation Instructions
1.
Close door completely. Keep door closed by
fastening “C” clamps on both the left and right
door track against the top side of two rollers.
2.
Disconnect power and lifting arm of garage
door opener.
3.
(FOR TOP ROLLERS GO TO STEP 4) Unbolt
hinge from door. Feed roller into new hinge
tube furthest from door. Place roller wheel
into track and bolt hinge to door. Replace and
tighten one hinge at a time before proceeding
to the next step.
4.
For Top Rollers only-install an additional “C”
clamp in door track engaged in door so top
section of door is restrained from rotating
down when the bracket is removed. Replace
brackets or rollers ONE AT A TIME, moving “C”
clamp or locking pliers to prevent door section
from pivoting. Install roller into bracket and
feed roller into track. Fasten bracket to door
and use adjusting bolt on bracket to snug door
against jamb.
WARNING! !
IMPROPER INSTALLATION OR DOOR POSITION CAN RESULT IN SERIOUS INJURY OR DEATH.
•
Read and understand all instruction before you begin work.
•
Wear safety googles and gloves.
•
Unplug power door opener and remove opener travel arm from door FIRST.
•
Do not remove more than one part at a time.
•
Do not attempt to raise or lower door without all components installed and securely
tightened.
•
Extension and torsion springs, along with attached hardware are under extreme tension at
all times.
•
All tension must be released from springs before any work is started.
•
This hardware is intended for residential garage doors only.
•
If you do not completely understand the installation instructions or are unsure whether the
replacement part matches the part to be replaced, contact a professional installer.
Vice grips
Wrench
C-Clamps
Tools Needed:
Holmes-Hally Industries
www.holmese900hardware.com
2” 13-BALL NYLON
GARAGE DOOR ROLLERS