Owners manual

5
IMPORTANT: Inspect the choke wires and terminals on the choke cap to ensure there is adequate clearance between the
choke cap and the back of the TPS bracket. If there is not enough clearance, adjust the wires and tie back with
a zip tie or equivalent to ensure proper clearance is achieved.
10. Install the Throttle Position Sensor to the bracket using the supplied screws, flat washers, lock washers, and mounting
plate. The TPS bracket is designed so the TPS can be adjusted to obtain the proper voltage needed for the application
it is being utilized for. (See figure 12)
NOTE: Prior to and after installing your new TPS kit, manually operate the throttle lever to check for binding or other
malfunctions.
Figure 12
11. A TPS connector with pigtail is included in the kit. Figure 13 shows the pin out for the Throttle Position Sensor. The
wire colors on the connector with pigtail are as follows:
• Blue = Output wire
• Black = Ground
• Grey = +5 Volt reference
I
MPORTANT: This TPS kit is intended to be used with data acquisition or for use with an electronic transmission.
Please refer to the instructions for your data acquisition or transmission control module for wiring and
voltage output information.
Figure 13