Owners manual

3
Figure 4 Figure 5
5. Remove the fast idle screw and retaining clip from the original fast idle lever and install on the new fast idle lever from the
kit. Make sure you count the threads on the screw and install in the same position. (Figure 5)
INSTALLATION:
1
. Install the TPS cam into the D-slot of the new fast idle cam and retain with the supplied C-clip. (Figure 6)
2. Install the fast idle lever and cam assembly onto the primary throttle shaft and retain with the Phillips head screw removed
in step 4 of disassembly. Torque to 8 in/lbs minimum. (Figure 7)
Figure 6 Figure 7
3. Re-attach the choke rod to the choke lever on the back of the choke housing and install the retaining clip from step 2 in
disassembly. Make sure the choke rod is below the red plastic fast idle cam as shown in figure 8.
Figure 8 Figure 9