Owners manual

2
CARBURETOR REMOVAL:
1. Remove the air cleaner, exercising care to carefully detach any vacuum lines to the air cleaner and marking them so they
can be reassembled to the air cleaner in the same manner.
2. Remove the carburetor by the following procedure:
A. Carefully disconnect the fuel line.
WARNING: Carefully protect the open end of the fuel lines, so that no foreign particles can enter. Wrap
the end of the fuel line with a clean lint-free cloth.
B. Disconnect and mark all the vacuum lines to the carburetor.
C. Disconnect the PCV hose.
D. Disconnect the choke positive wire.
E. Disconnect and remove the throttle linkage and automatic kickdown linkage. SAVE ALL RETAINING CLIPS.
F. Unbolt and remove the carburetor from the manifold.
CHOKE REMOVAL:
1
. Mark the choke index position for easy reassembly, Remove the choke cap by removing the three choke cap clamp screws
and set aside. (Figure 1) Remove the choke cap gasket and set aside.
Figure 1
2. Remove the retaining clip from the choke rod to choke shaft and set aside. (Figure 2)
Figure 2 Figure 3
3. Remove the choke housing assembly from the carburetor main body by removing the three Phillips head screws and set
aside. (Figure 3)
NOTE: There is a cork gasket on the backside of the choke that seals a vacuum passage to the main body. Do not
discard as it will be reused.
4. Remove the Phillips head screw from the end of the primary throttle shaft as shown in figure 4. Remove the fast idle lever
from the primary throttle shaft.