Owners manual

5
Figure 5
5. Remove tape from the hole edge and then clamp the 3/8” rubber hose to the right angle adapter and install on the
bulkhead feed thru. Be careful not to allow any portion of the HydraMat or suction hose to bind the motion of
the fuel level sender float if one is used. (Figures 6 & 7)
Figure 6 Figure 7
6. Tie wrap the return fuel hose against the fuel pick up hose. Position the end of the hose approximately 1” above the
HydraMat (Figures 8 & 9).
Figure 8 Figure 9