Owners manual

2
AVAILABLE KITS AND ADAPTERS:
P/N
Description
P/N
Description
26-148
Fuel Bulkhead Kit
AT984088ERL
Straight 1/2” Hose Barb to 1/2” NPT Male
26-151
4 Wire Bulkhead Kit
AT984010ERL
Straight 5/8” Hose Barb to 1/2” NPT Male
26-152
2 Wire Bulkhead Kit
AT981608ERL
3/8 NPT Adapter Pipe Thread to AN -8
26-161
3/8 I.D. x 2’ Submersible Rubber Hose
AT981610ERL
1/2 NPT Adapter Pipe Thread to AN -10
AT984008ERL
Straight 1/2” Hose Barb to 3/8 NPT Male
AT981666ERL
3/8 NPT to -6 AN Fuel Line Adapter
AT984066ERL
Straight 3/8” Hose Barb to 3/8 NPT Male
AT165206ERL
3/8 Hard Line to 3/8 NPT
AT984068ERL
Straight 3/8” Hose Barb to 1/2” NPT Male
AT165256ERL
5/16 Hard Line to 3/8 NPT
IMPORTANT NOTES:
1.0 FUEL COMPATIBILITY:
Works with all gasoline blends (Alcohol, Ethanol, Methanol, and E-85). Not for use with oils, diesel fuels, or any other
fluids.
2.0 NO PRE-FILTER NEEDED!
All HydraMats are constructed with a 15 micron depth media, so no pre-filtration is required for the fuel pumps. Use of an
additional pre-filter could result in pump failure.
3.0 HYDRAMAT FILTER LIFE EXPECTANCY
The HydraMat filtration performance will provide 5-10 years or more depending on the fuel type, how clean your fuel
system is, how much you drive your car, and how aggressively the car is used. Severe duty applications should inspect
the filter at regular intervals to ensure the Hydramat is not restricted by debris. The Hydramat is not cleanable.
4.0 HYDRAMAT CLEANING
The large majority of the debris is imbedded inside the depth media and cannot be removed. Surface cleaning is not
practical or effective and should NOT be done. In extreme conditions (Racing or Off Road) check your HydraMat
annually.
5.0 CLICK BOND INSTRUCTIONS
Kit number 16-201 is intended for steel or aluminum fuel tanks.
Kit number 16-202 is intended for polypropylene or polyethylene fuel tanks.
Position the HydraMat on the floor of the fuel tank in the preferred location. Mark the tank surface thru the mounting holes
in the HydraMat for the position of each stud. Follow the directions provided in the Click Bond kit for cleaning and
adhesive application. Allow to dry for 24 hours. Unscrew the plastic frame and slide the HydraMat over each stud. Open
kit bag and install the washer then tighten the nut to 7-10 IN. LBS.