Owners manual

4
NOTE: It is essential that a quality inline fuel filter be installed between the fuel pump and the carburetor.
Figure 5
15. Install a suitable manual choke cable, such as Holley P/N 45-228 and choke mounting bracket P/N 45-229. Check to make sure that the
choke fully opens with the cable.
16. Start the engine and check the fuel line and inlet fittings for possible leaks. At this time, recheck to assure all existing vacuum hoses are
attached properly. Plug any fittings that are not used.
17. Adjust the idle using the idle mixture screws (clockwise adjustments lean the mixture, counterclockwise richens the mixture). As a starting
point, set the needles 1 1/2 turns out from the full lean position, and then adjust for best idle.
18. Install the air cleaner stud from unassembled parts. Place the air cleaner gasket on the carburetor air cleaner sealing flange. Install the air
cleaner.
WARNING: Inadequate clearance between the air cleaner and the throttle lever could result in uncontrolled engine speed. Check the
clearance between the choke, manual choke lever, and the air cleaner for proper operation.
Figure 6