Installation Guide

ManualsBrandsHOLDRITE ManualsPipe Support & Clamps704-L

CONVERTING MAKESHIFT METHODS INTO ENGINEERED SOLUTIONS

PEXRITE

The Torchless Installation

™

Visit www.HOLDRITE.com to view PEXRITE

installation videos, technical information, and list pricing.

PICK YOUR STUB-OUT METHOD

PEX STUB-OUT

PEX TO COPPER STUB-OUT

PEXRITE

Turn-Out

PEXRITE

Lock-n-Load

™

#701

#704

#702

Summary of content (4 pages)

PAGE 1
PEXRITE ® CONVERTING MAKESHIFT METHODS INTO ENGINEERED SOLUTIONS SM The Torchless Installation ™ ® PEXRITE Turn-Out PEX STUB-OUT #704 PICK YOUR STUB-OUT METHOD #702 #701 PEXRITE Lock-n-Load ® ™ PEX TO COPPER STUB-OUT Visit www.HOLDRITE.com to view PEXRITE® installation videos, technical information, and list pricing.
PAGE 2
Pick Your Stub-Out Method PEX SUPPORTS For over fifteen years, HOLDRITE has been the expert in pioneering and producing innovative PEX support products. PEXRITE , The Torchless Installation™, allows contractors to quickly install PEX tubing regardless if they stub-out in PEX or copper tubing. ® As the industry leader in PEX tubing supports, our engineering design team has observed our PEXRITE technologies successfully installed by contractors.
PAGE 3
PEXRITE® The Torchless Insatallation™ PEXRITE Turn-out #704 Installation Instructions ® 1 Install PEXRITE bracket to studs. 2 Insert #704 into bracket from the front. 3 Position #704 until bracket fits into groove, then rotate into place. 4 Insert PEX tube at 45° angle and set stub-out length. 5 Bend tube forward and snap into #704. 6 Complete! No concealed joint in the wall. PEXRITE Lock-n-Load #701 Installation Instructions ® 1 Install PEXRITE bracket to studs.
PAGE 4
PEXRITE ® CONVERTING MAKESHIFT METHODS INTO ENGINEERED SOLUTIONS SM THE TORCHLESS INSTALLATION ™ PEXRITE® Lock-n-Load #702 Installation Instructions 1 Install a PEXRITE bracket onto the front of wall studs. 2 4 Slide a ¾” tube or bullet through the insert. Lock the tubing in position by tightening the grey nut clockwise, by hand. 5 Snap the main purple body of the insert into the front of the bracket. 3 Snap the grey nut onto the back of the purple insert. Installation is complete.