Installation Guide
IV.
WALL
MOUNT
(Concrete
Only)
QUICK
STAND™
#40-SWHP-W,
#40-SWHP-WM
QUICK
STAND™
#50-SWHP-W,
#50-SWHP-WM
WALL
MOUNT
INSTRUCTIONS
1.
Cut-out template printed on box, tape it to the wall
in
desired
location and mark the four anchor locations on wall.
2. Drill four holes
in
concrete wall to the recommended depth
specified by the anchor manufacturer (use 3/8" dia. anchors rated
for the weight
of
this platform).
3.
Install and tighten item
'0'
concrete anchors. Allow min. 5/8"
of
threads exposed. (Fig #1)
4. Affix item
'J' 45° Brackets (4) to ends
of
both 3/8" threaded
rods item 'Q'. (Fig #2)
5.
Affix one rod assembly to each
of
the two upper concrete wall
anchors (finger tighten concrete anchor nuts
& washers). (Fig #3)
6. Affix set
of
item 'K' brackets to the two lower anchors.
The orientation
of
the slots
in
the brackets must be
horizontal and face each other. (Fig #4)
7.
Position platform
in
lower set
of
item 'K' brackets, aligning the hole
of
the drain pan's corner brackets with the slots
in
item 'K' brackets.
(Fig #5)
7.1. Slide item 'N' carriage bolts up through rear corner holes
of
drain
pan and through item 'K' brackets. Install item 'C' washers and item
'D' nuts on each bolt and tighten. (Fig #5)
8.
Align item 'J' brackets with the holes
in
the front corner brackets
of
the platform.
8.1. Slide item 'N' carriage bolt bottom up through front corner holes
of
drain pan, and slide item 'C' washer on bolt shaft and hand tighten
item 'D' flanged nuts. (Fig #6)
9.
Tighten the flanged nuts at the four corners
of
the platform and the
nuts at each wall anchor.
9.1. Tighten all hardware securely (If vibrating equipment will be
mounted, Loctite®
or
similar is recommended)
1
0.
On platform versions with a plastic drain assembly, install
drain fitting. Always place rubber gasket between the fitting
and the metal pan for proper seal. (Fig #7)
11.
Set water heater on platform.
Fig #1
Fig
#3
Fig
#5
11.1.
In
seismic regions, install QUICK STRAP® earthquake
restraint kit around water heater per manufacturer's
instructions.
Completed
Installation
'J'
Bracket
/
'Q'
All
Thread
/
Fig
#4
Fig
#6