Installation Guide
Ill.
CEILING
MOUNT
QUICK
STAND™
#40-SWHP,
#40-SWHP-A,
#40-SWHP-M
QUICK
STAND™
#50-SWHP,
#50-SWHP-A,
#50-SWHP-M
CEILING
MOUNT
INSTRUCTIONS
1.
Install anchors & hanger rods to overhead structure, using
appropriate hardware. (Use template printed
on
back
of
box
(See Page
2).
2.
On models with PVC drain body, assemble plastic fitting,
gasket and conduit nut into large drain hole
in
pan, selecting
either the threaded or slip end to be outside the pan for later
drain line attachment. Always place rubber gasket between the
fitting and the metal pan for proper seal.
(Fig #2)
3.
Install four item 'M' washers and four item 'L' nuts onto support
rods at desired height. Insert all four rods item 'R' through
platform corner brackets and raise platform to meet nut and
washer at desired height. Level platform carefully and support
in
place while installing four item 'M' washers and four item 'L' nuts
onto support rods below platform corner brackets.
(Fig #3)
(If Steps 6 & 7 apply, install 2 ea.
of
item 'L' and 'M' at
appropriate height on all
four
item 'R' rods)
4. Tighten all hardware.
5.
Place water heater/equipment
on
platform, orienting to provide
proper access to controls and connections.
Steps
6 - 9
are
for
seismic
zones
use
only
(Models
#40-SWHP, #50-SWHP)
6.
On seismic models, assemble the pair
of
item 'T' cross braces
like an "X", so notches
in
center interlock. (Fig #4)
7.
Lay assembly
on
top
of
water heater, pulling cross brace
assembly down snugly against top
of
water heater (Fig #5)
(If
T
&P
relief
valve
is
centered
at
the
top
of
the
water
heater,
install
the
T
&P
relief
valve
through
the
hole
provided
at
the
intersection
of
the
cross
braces.)
8.
If permitted by water heater manufacturer, secure cross brace
assembly to top
of
water heater using
#1
0 X 3/4" to
1"
(max)
sheet metal screws.
9.
Install seismic
or
sway bracing as required. Attach "installer
provided" seismic hardware to the corners
of
the platform and
appropriate structural anchorage.
10.
Install and route drain line as required.
1
I•
jl
II
'R' All
Th,..d
~~~
J
••
I
Fig
#2