Installation Guide

R
E
Install Splash Guard
Fig 1
W
1.
Please see Fig 1 for details:
NOTE: the handle holes face
the shower head wall.
Then, measure the distance
between two finished walls.
This distance is marked as W
in the figure.
Cut the Splash Guard (6) to
Place the Inside Shower Door
(8) inside the shower on a soft
mat or piece of cardboard.
Please see Fig 2 for details
2. Draw a guideline 3/8” from the front of the shower threshold according to the
instructions on page 6. Place the front of the Splash Guard (6) along this guideline, then
secure the Splash Guard with short strips of painters tape.
Front
Painters Tape
6
Showerhead
this wall
1. Drill hole and evacuate all debris
2. Insert silicone into the hole
into a vertical, horizontal or sloped surface of a tub,
shower, wall or ceiling, otherwise moisture damage
can occur:
Sealing Screws and Anchors:
Follow these steps when drilling, anchoring or screwing
4. Position part over hole/anchor, insert screw and tighten
b. Insert silicone into anchor and any open gaps
3. If using an anchor:
a. Insert anchor (cut anchor shoulder off if it interferes
with part being attached)
5. Apply silicone around diameter of screw head and over
the top of the screw
READ THIS FIRST BEFORE BEGINNING INSTALLATION TO HELP AVOID FUTURE WATER DAMAGE