Installation Guide

Caulk Unit with Silicone Sealant
16. Remove any painters tape used during installation and clean surfaces with denatured
alcohol. Apply a continuous bead of high quality, clear 100% silicone on the outside of the
unit where it meets the wall and threshold. Specifically, run the silicone down the Wall
Profiles (4L)(4R) at the wall, and along the Splash Guard (6) at the threshold. On the
outside of the unit, caulk the vertical joints where the Splash Guard (6) meets the Wall
Profiles (4L)(4R) and the Center Guide (6).
See Figure 16 for details.
Fig 16