Installation Guide

Page 7
Installation Instructions
Large Threshold Radius
marker or pencil (dotted line, Fig #8).
ALTERNATE STEP 1 - Large Threshold Radius
a. Mark the centerline onto the threshold using a water soluble
e. Insert the glass panel (1) into the channel (Fig #10).
c. Add the 1/2” glass setting blocks (7a)
f. Adjust the glass panel (1) until there is a 1/8” gap between the
1 1/4” of the wall. This will guarantee the glass will fit securely
inside the wall channel (Fig #10).
d. Secure the bottom channel with painters tape
i. Cut the bottom channel where marked
b. Using the hacksaw and file, add a radius to the
j. This is the end of the special instructions for the large radius
installation. Return to Step 1c on page 4.
bottom channel (2) to match your bathroom (Fig #9).
panel and the radius of the shower. Ensure the panel is within
h. Remove the glass panel (1) and bottom channel (2) from the
shower
g. Mark the edge of the glass panel
Setting
Blocks
(7)
1 1/4” Max
Fig #10 Fig #9 Fig #8
1/8” Gap