Installation Guide

Page 5
Installation Instructions
All Models
b. Attach wall channel using anchors and/or screws and
a. Set Panel in place into the Bottom Channel and
that the EasyClean coating is on that side. Face the EasyClean
b. Plumb the exposed edge of the panel by using the
coating towards the inside of your shower.
NOTE: If you have a GridTech panel, the grid pattern should
d. Apply silicone into the bottom channel where it meets the
top of the panel sill. Use a level to plumb it and mark holes
follow Read First - Anchors and Screws instructions. If
a. Drill 3 holes in Wall Channel, Item (3) and set in place on
STEP 2 - WALL CHANNEL
on wall. Remove channel. Fig #4
wet sealing - Insert 3 centering clips at top, middle and
bottom.
STEP 3 - ALIGNING PANEL
Wall Channel. One side of the panel will have a sticker showing
be on the outside of the shower area.
assorted setting blocks (7d) to raise the bottom corners as
required.
c. Once the glass is plumb and you are happy with the alignment
of the panel with the wall channel, remove the glass panel.
wall to keep water from running out (Fig #5).
Fig #4
Wall
Channel (3)
Fig #5
Wall
Channel (3)