Installation Guide

Anchors and Screws:
When drilling, anchoring or screwing into a
vertical, horizontal or sloped surface of a tub,
shower, wall or ceiling, follow these steps
otherwise moisture damage can occur:
1. Drill hole and evacuate all debris
2. Insert silicone into the hole
3. If using an anchor:
a. Insert anchor (cut anchor shoulder off if it interferes
with part being attached)
b. Insert silicone into anchor and any open gaps
5. Apply silicone around diameter of screw head and over
the top of the screw
4. Position part over hole/anchor, insert screw and tighten
R
E
A
D
F
I
R
S
T
R
E
A
D
F
I
R
S
T
Installation Instructions
All Models
e. Reread note on Horizontal surfaces and installation
holes on page 2 and Read First - Anchors and Screws
instructions above.
b. Prepare Bottom Channel:
after Glass Panel is in final position.
OR
- WET SEAL: Three Centering Clips (7d) will be
inserted into the sill between setting blocks. You will have
to silicone both sides of the panel to the glass.
Ensure these weep holes are oriented to the inside of
STEP 1 - Bottom Sill
NOTE: If your threshold has a radius above 1/2”, see
ALTERNATE STEP 1 on page 6.
f. Drill 3/16” holes in aluminum bottom sill. Mark screw hole
locations on threshold (Fig #3) and follow Read First -
Anchor and Screw instructions.
a. Mark the centerline onto the threshold using a water
soluble marker or pencil (dotted line, Fig #1).
manufacturer opted to put weep holes in the curb.
c. Insert two 1/2" Clear Setting Blocks, Item (7a).
d. Choose the glazing method (Fig #2):
- DRY SEAL: Will use two pieces of Snap Vinyl Item (4)
the shower.
- Measure the width of the Glass Panel and add 3/4".
- Cut the Bottom Channel (2) to this length.
- Due to the single panel design of this unit, the
f. Insert the U-Channel End Cap (6) into the channel and
secure with painters tape.
Fig #1Fig #2
Silicone
Bead
Centering
Clip (7d)
Wet Glazing
Parts Detail
Dry Glazing
Vinyl Detail
Snap Vinyl
Clip (7d)
Setting
Blocks
(7a)
Choose Glazing Method
Page 4
Fig #3
Bottom
Channel (2)
U-Channel
End Cap (6)