Installation Guide

STEP 18 - Silicone: GE1200 Recommended
* Run a vertical bead of Clear Silicone on the outside and
inside of Tub Jambs where they meet the tile.
* Run one continuous bead along the bottom outside and
inside of the Soft Sill crossing the Center Guide.
STEP 19 - Towel Bar and Pulls:
* Start with the blind Fastener of the Towel Bar first. See the detail below for proper sequence.
* Ensure the plastic hole grommet inside the holes in the glass. Failure to do so could result
in the panel chipping or breaking, etc. Follow sequence 1st, 2nd, 3rd below.
STEP 16 - Install Black Screw Cover Vinyl:
* Insert one length of VN.4303 vinyl (13), into center slot over
to cover the screw heads and slot from top to bottom.
* Snap in place by pushing vinyl towards the wall until it
snaps into place, working your way down.
* Work vinyl until it has a constant reveal.
Page 8
Measure
from jamb
to center
guide
Soft Sill Vinyl
with Tape (14)
Center Guide
(6)
Measure
from jamb
to center
guide
Cover Vinyl
(13)
Short
Knob
Short
Knob
Blind
Fastener
Tall
Knob
Hole
Grommet
Hole
Grommet
Hole
Grommet
Flat
Washer
Flat
Washer
Flat
Washers
Threaded
Stud
Threaded
Stud
1st
2nd
3rd
Apply Silicone on the outside
of the unit Full Height both walls
Continuous Single Bead across bottom wall to wall
Installation Instructions
Models: TRBTE / TRBSE
ECBTE / ECBSE
3/8" Frameless Slider
STEP 17 - Installing Soft Sill #14:
* Measure between the Center Guide #6 and a Tub Jamb.
* Cut Sill to this dimension. Repeat for second Tub Jamb.
* NOTE: Clean adhesion surface with alcohol and dry
thoroughly.
* Peel the backing off the tape on the sill and stick in place.
between the Center Guide and the tub Jamb.
* Repeat for second sill.