Installation Guide

Page 7
STEP 14 - Adjusting Rollers and Sliding Panels:
* Using the two 3mm Allen wrenches supplied in the part bag
to rotate inner cam/plate to raise or lower roller.
* Adjust each Panel until they seat properly with the Tub Jambs
vinyls.
* Tighten Outer Cap while holding cam/plate in adjusted position.
* NOTE: there are holes on both sides of the cap and cam/plates
to ease adjustment.
STEP 15 - Install Anti Jump Posts #2:
* Assembly Anti Jump Posts to glass as shown.
* Snug post to glass, then rotate Outer cam/cap to raise or lower
Anti-Jump post until it is 1/16” from bottom of tube.
* Tighten Anti-Jump post while holding Outer cam/plate in
adjusted position to maintain the 1/16” gap.
* NOTE: there are holes on both sides of the post and cam/cap
to ease adjustment.
3mm
Allen
Wrenches
STEP 13 - Cut and Install Tub Jambs: reference diagram below
* Measure / Cut Left Tub Jamb
- Measure from the threshold to the bottom of the Wall Plate (5) on left wall.
- NOTE: Threshold may be angled downward for drainage. This angle should be cut onto the bottom of the Tub Jamb.
- Cut left Tub Jamb (10) to measured length.
* Position Left Jamb Tub Jamb and Locate and Drill Installation Holes:
- Position Left Tub Jamb under the center of the left Wall Plate.
- Move the outside panel to the closed position so it freely pockets into VN.4103 without twisting. Adjust as needed.
- With felt tip pen/marker, mark where you want you 1 ½” long wall attachment screws to go (use 3 or 4 per side).
- Remove jamb from wall, lay on flat surface and drill holes at marked location with 3/16” drill bit into aluminum jamb.
* Install Left Jamb Tub Jamb:
- Reposition tub jamb in same location as last step. Mark hole location through jamb onto wall. Remove jamb.
- Drill 3/16” holes into wall at marked locations. Insert wall anchors.
- NOTE: razor blade wall anchor shoulders off if needed. Shoot silicone into wall anchors before next step.
- insert 1 ½” screws to attach jamb to wall and snug to wall.
* Repeat this step for the right Tub Jamb (vinyl sides will be reversed)
1 ½” x wall
attachment
screws
(mark/drill here)
Shower
Head Wall
TOP VIEW - TUB JAMBS
VN.4301
VN.4102
VN.4102
INSIDE SHOWER
VN.4301
wall anchor
shoulder may
have to be
removed
Outer cap
tightens roller
to glass
Inner cam/plate
raises/lowers
glass
Holes on both sides of
caps/plate to ease adjustment
Outer cam/cap
raises/lowers
anti-jump
1/16”
gap
Center
Guide
Installation Instructions
Models: TRBTE / TRBSE
ECBTE / ECBSE
3/8" Frameless Slider