Installation Guide

3mm
Allen
Wrenches
INSIDE
PANEL
(towards
showerhead)
OUTSIDE
PANEL
INSIDE OF
GLASS
OUTSIDE OF
GLASS
STEP 10 - Install Sliding Panels:
* Inside Sliding Panel:
- Starting with Inside Panel (#17, showerhead wall), mount
two Roller/Wheel l assemblies (#1) as shown Detail J. The
flat Wheel face will face to the inside of the shower.
- Adjust the Wheel so you have equal up and down
adjustment. Tighten the Wheel securely as shown Detail K.
- Repeat for second Wheel #1.
- Hang inside panel the inside bar with the Panel between
the Header Tubes.
* Outside Sliding Panel:
- NOTE: Carefully slide the top of outside panel between
the two tubes before installing rollers.
- Mount both Wheels using same procedure as above,
except have them facing to the outside of the shower.
* Reference Detail K:
- Tighten the Wheels securely using two 3mm Allen Wrenches.
STEP 11 - Install Center Guide:
* Move both panels middle of header tubes.
* Slide the Center Guide under both panels and align with
marks made in STEP 3.
- Using a level, check each panel for being plumb.
- Adjust Center Guide forward or back to achieve best plumb
result (OK to split the difference if there is a slight rake).
* Mark the holes onto the threshold
- Drill hole into threshold with a 1/4" bit.
- Fill the hole and anchor with silicone.
- Insert two Wall Anchors (7e).
- Add silicone to the bottom the guide to keep water
out the hole.
See Detail L
* Secure with two #10 X 1-1/8" screws (7d).
* Carefully move each Panel to the closed position.
J
K
Slide/Insert
Part 11
(VN.4301)
Do not install
VN.4303
Tub Jamb
Part 10
(EX.1351)
H
Distance should 2 ½”
from inside to inside of tube
at both sides of the unit.
Page 6
STEP 12 - Prepare Tub Jambs:
* Insert one piece of vinyl (11) and into the "T" slot
* Insert one piece of vinyl (12) into the other slot. Orient the
vinyls as shown.
* Repeat for second Tub Jamb
* Do not install vinyl (13). You will do this after the jambs are
screwed to the walls to cover the screw heads.
L
Slide/Insert
Part 12
(VN.4302)
Installation Instructions
Models: TRBTE / TRBSE
ECBTE / ECBSE
3/8" Frameless Slider