Installation Guide

STEP 9 - Mount Header Tubes:
Reference Detail G*
* NOTE: Ensure pucks are 3 1/2” apart at both ends.
* NOTE: Since full tub jamb system is used,
the Bumper Stops are optional. They can be used at
the discretion of the owner. Stoppers are not shown on these
instructions. IF DESIRED BY OWNER: Carefully slide
two Bumper Stops #3.
* Slide opposite wall collar onto tube (the other collar should
still be on the wall).
* Slide Header Tube assembly into the secured Wall Collar,
align with other side and slide the loose Wall Collar onto
the other Wall Puck and secure by tightening the set
screws.
* Repeat for second bar. Ensure all set screws are tight so
that the Glass Panels cannot fall when installed.
Tube Assembly
Slide wall collar
onto puck
Slide assembly into
secured Collar
G
STEP 7 - Assemble Opposite Wall Plate and Tubes
* Reference Detail E (upper)
- Attach two Wall Pucks to the remainingWall Plate with
the slots in a vertical position
- Use two M6 X12mm Cap Screws and washers like in
STEP 5
- Again, ensure cap screw does not extend through back
Failure to do so could result in cracked tiles, etc. See Detail C
- Attach Wall Collars onto the pucks.
- Attach two Wall Collar (#4) onto the Wall Pucks, Detail D
- Tighten bottom Wall Collar set screws into Pucks first
- Tighten top Wall Collar set screws into Pucks second
- Reverse the order when tightening set screws into
bars (headers) in future steps.
* Reference Detail E (lower)
- Insert two Header Tubes, #9 into the assembled Wall plate
and tighten set screws.
STEP 8 - Locate and Secure Opposite Wall Plate
* Reference Detail F:
- THIS STEP REQUIRES ASSISTANCE
- Carefully lift wall plate/tube assembly and insert the
other open ends of the tubes into the Wall plate already
mounted on the wall (high side).
- Using level, position loose Wall Plate/tube assembly until
tubes are level and the wall plate is center on Centerline.
- Mark an outline around the Wall Plate onto the wall.
- Carefully lower assemble and completely disassemble
components
* Align the Wall Plate to the outline you made and mark
the four countersunk mounting holes onto the wall.
- Drill with four hole into wall with 1/4" drill bit
- Insert wall anchors.
- Secure wall plate with four #10 X 2" Screws.
- Attach two Wall Pucks to the Wall Plate with slots in a
vertical position using cap screws and washers used in
STEP 6
Assemble parts to look like above
Do not attached to wall yet.
E
AlreadySecured
to wall
(High Side)
Position until level
and centered
F
Assistance needed for this step.
Unit Centerline
3 ½”
Page 5
3 ½”
Orient the
slot in Puck
vertically
when
securing.
Wall Collar
(orient cone
tipped set
screws into
puck)
Installation Instructions
Models: TRBTE / TRBSE
ECBTE / ECBSE
3/8" Frameless Slider