Installation Guide

STEP 3 - Determine Centerline on Threshold and Walls:
* Mark Center Guide #6 location on threshold.
* Center guide at center of threshold width and depth.
Do not install yet!
* Wall plates will be centered on the center of the guide.
* Laser or plumb-bob is handy to determine and mark the
overall centerline of the unit. See Detail A
STEP 2 - Evaluate Threshold:
* Maximum recommended vertical threshold outage from
side to side is 1/4".
* Mark high-side and low-side of threshold.
* First wall plate will be installed on high-side.
STEP 1 - Wall Plate Height Calculation:
* Measure height of glass panels: ___________
* Subtract 3 11/16" from this measurement: ___________
* New measurement is the height from the threshold to the
bottom of the First Wall Plate #5 in Step 3.
Low (1/4” max)
High Side
Threshold
Slider glass panel height
- 3 11/16”
Height from threshold to bottom of Wall Plate
First (High Side)
Wall Plate
STEP 4 - Mount First Wall Plate on High Side:
* Take measurement from STEP #1 and measure up high-side
wall on the centerline.
* Mark this location as the BOTTOM of the Wall Plate #5.
* Center plate on the Centerline and mark the 4 hole locations.
* Drill four holes with a 1/4" drill bit,
- Insert 4- Wall Anchors #8b,
- Then secure with 4 - #10 X 2" screws, #8a.
High Side
Center
Guide (6)
Calculation
in Step 1
A
B
STEP 5 - Attach Pucks and Wall Collars
to Wall Plate on High Side:
.
* Attach two of Pucks (Remove from inside of
Wall Collars, #4 and attach them to the Wall Plate with
slots in a vertical position.
IMPORTANT NOTE: See Detail C.
- Use the fewest number of washers (#7c) to ensure
cap screw does not extend through back of plate.
Failure to do so could result in cracked tiles, etc.
- Use two M6 X 12mm Cap Screws (#7b) to secure pucks
* Attach two Wall Collar (#4) onto the Wall Pucks, Detail D
* Tighten bottom Wall Collar set screws into Pucks first
* Tighten top Wall Collar set screws into Pucks second
* Reverse the order when tighten set screws into
bars (headers) in future steps.
Washers
Step 4
finished
attached
to wall
D
2” Long
Screws
Pucks
Wall
Plate
Puck
Wall
Tile
Washers
Must not
protrude out
back side of
plate
C
Cap Screw
Page 4
Orient the
slot in Puck
vertically
when
securing.
Wall Collar
(orient cone
tipped set
screws into
puck)
Installation Instructions
Models: TRBTE / TRBSE
ECBTE / ECBSE
3/8" Frameless Slider
STEP 6 - Check Header Tube Length:
* Your Header Tube may already be cut to size. To check, measure wall to wall just below the Wall Plate and
subtract 1 3/4”. If your header is not this length, cut with a hacksaw. Cutting through reinforcement will be difficult.
* Seal both exposed ends of both headers/tubes with a light coat of silicone to prevent oxidation.
Wall to Wall - 1 3/4"