Brochure

S
Range Sensor
60
■ Connection
Input/output circuit
Wiring table
■ Available detection area
Straight
Note) This device shows the detection area on the basis of the center position of scanning.
Fan shaped
Ratio
Main circuit
-
Power for
sensor
+
-
Output1, 2, 3, 4
Input1, 2, 3, 4, 5
Output COM -
Input COM +
+VIN
-VIN
Power circuit
1kΩ
4.7kΩ
4.7kΩ
1kΩ
FG
I/O power
+
Load
Output1
Output2
Output3
UBG UBG
UBG
Input response time
Input reading frequency: 1 scan time (100msec) (Input reading frequency is 1msec when Laser is
switched off externally )
Start up Time Within 10 sec after power supply. (Varies with startup conditions)
Indication lamps
Power lamp (green): Flashes during startup or sensor malfunction
Output lamp 1/2/3 (orange): lights up during detecting object in area
Connection Cable 1m
Ambient illuminance
note3)
Halogen/mercury lamp: 10,000lux or less, incandescent lamp: 6,000lux or less
Ambient temperature/ humidity -10 to +50℃ (-25 to +75℃when stored), 85%RH or less, not icing, not condensing
Insulation resistance 10MΩ 500VDC megger
Vibration resistance Double amplitude 1.5mm, 10 to 55Hz, each 2 hour in X, Y and Z directions
Impact resistance 196m/s
2
, each 3 time in X, Y and Z directions
Protective structure IP64 (IEC standard)
Life 5 years (motor life, vary depending on use conditions)
Noise 25dB or less (at 300mm)
Case materials Front of case: Polycarbonate, back of case: ABS resin
Weight Approx.185g (260g including cable 1m)
＊
Accuracy is a value when shipment.
Note1) Output 1/2/3 turn OFF when malfunction output operated.
Note2) If area is changed, 1 more scanning time is delay.
Note3) It may malfunction when receiving strong light like sunlight etc. directly.
★It can download the area setting software from our website.
★RS-232C cable (UZ00002) is available as an option.
Cable colors Signals
Black Output 1
White Output 2
White (blue) Output 3
Orange Malfunction output
Gray Output common minus
Red Input common plus
Green Input 1
Yellow Input 2
Purple Input 3
White (yellow) Input 4
White (purple) Input 5
Brown +VIN (24VDC)
Blue -VIN
Yellow (red) Serial input (RXD)
Yellow (green) Serial output (TXD)
Yellow (black) Serial GND
Note1) Colors inside ( ) suggest wires with colored lines on either sides.
Note2) Leave the unused input terminals open or connect to input
common plus (red).
Leave the unused output terminals open or connect to input
common minus (gray).
Note3) I/O direction is on the basis of UBG.