Installation & Assembly

ManualsBrandsHokku Designs Manuals7 Piece Kitchen & Dining Room SetsRegan 7 Piece Extendable Dining Set

Turn right (clockwise) to tighten

Page 6 of 6

#D x 4 pcs

#E x 4 pcs

#F x 4 pcs

I. Prepare 4 bolt assemblies by inserting FIRST the lock washer (#E) onto the

bolt (#D) and then the flat washer (#F) onto the SAME bolt (#D), in that

order.

II. Insert the bolt assemblies through the pre-drilled holes in the corners of the

seat (#2) and secure those bolts using the Allen wrench (#K) to lock them in

with the backrest with legs (#3).

ASSEMBLE EVERYTHING EXACTLY THE SAME FOR THE SECOND CHAIR

I. Align the right armrest (#4) with the pre-

drilled holes of the backrest with legs (#3)

AND the seat (#2).

II. Prepare 2 bolt assemblies by inserting

FIRST the lock washer (#I) onto the bolt

(#A) and then the flat washer (#J) onto the

SAME bolt (#A), in that order.

III. Insert those bolt assemblies through the

seat (#2) and secure those bolts using the

Allen wrench (#G) to lock them with the

right armrest (#4).

IV. Secure the other end of the right armrest

(#4) with a wood screw (#H) using a

Phillips screwdriver to lock it with the

backrest with legs (#3).

V. Repeat the process above to assemble

the left armrest (#5) onto the backrest with

legs (#3) AND the seat (#2).

VI. Make sure the chair is rested on a flat

surface and does not feel loose or wobbly.

If it does, double check that the bolts are

secured and properly tightened.

Note: Right and left are

determined by facing the

front of the chair in the

upright position.

#A x 4 pcs

#H x 2 pcs

#I x 4 pcs

#J x 4 pcs

1. Prepare 4 bolt assemblies by first

inserting the lock washer (#E) onto

the bolt (#D) then a flat washer (#F)

onto that same bolt (#D), in that order.

2. Insert 2 bolt assemblies into

each corner along the back

of the seat (#2) and secure

using the Allen wrench (#K).

1. Prepare 4 bolt assemblies by first

inserting a lock washer (#I) onto

the bolt (#A) then a flat washer (#J)

onto that same bolt (#A), in that order.

2. Align the top end of the right armrest (#4)

to the holes along the backrest w/legs (#3)

and the bottom end to the seat (#2). Then

insert a screw (#H) to the top end and

secure using a Phillips screwdriver.

3. Insert the prepared bolt assemblies into

the bottom end of the armrest to lock with

the seat. Secure using the Allen wrench (#G).

Right

Left

4. Repeat the process for the left armrest (#5)