Installation & Assembly

ManualsBrandsHokku Designs Manuals7 Piece Kitchen & Dining Room SetsRegan 7 Piece Extendable Dining Set

I. Place the backrest with legs

(#3) on a protected surface.

Align the seat (#2) with the pre-

drilled holes of the backrest

with legs (#3).

II. Prepare 2 bolt assemblies by

inserting FIRST the lock washer

(#E) onto the bolt (#B) and then

the flat washer (#F) onto the

SAME bolt (#B), in that order.

III. Insert the bolt assemblies

through the pre-drilled holes

near the center of the seat (#2)

and secure those bolts using

the Allen wrench (#K) to lock

them with the backrest with

legs (#3).

Turn right (clockwise) to tighten

Page 5 of 6

#C x 4 pcs

#E x 4 pcs

#F x 4 pcs

#B x 2 pcs

#E x 2 pcs

#F x 2 pcs

I. Place the seat (#2) facing down on a protected surface. Align

the two front legs (#1L / R) with the pre-drilled holes on the

corners of the seat (#2).

II. Prepare 4 bolt assemblies by inserting FIRST the lock washer

(#E) onto the bolt (#C) and then the flat washer (#F) onto the

SAME bolt (#C), in that order.

III. Insert the bolt assemblies through the corner holes of the seat

(#2) and secure those bolts using the Allen wrench (#K) to lock

them with the front legs (#1L/R).

#1L

#1R

2. Prepare 2 bolt assemblies by

first inserting the lock washer

(#E) onto the bolt (#B) then

the flat washer (#F) onto that

same bolt (#B), in that order.

1. Place the seat (#2) face down

onto a protected surface.

2. Prepare 4 bolt assemblies by first inser-

ting the lock washer (#E) onto the bolt

(#C) then the flat washer (#F) onto that

same bolt (#C), in that order.

3. Align the front legs (#1) to the

pre-drilled holes located on the

front corners of the seat (#2).

Then insert a prepared bolt

assembly into each hole and

secure using the Allen wrench.

1. Carefully place the backrest w/legs

(#3) onto a protected surface.

3. Align the back side of the seat (#2) to

the pre-drilled holes along the front

of the backrest w/legs (#3). Insert a

prepared bolt assembly into each hole

and secure using the Allen wrench (#K).

Note: Left and right are

determined by facing

the front of the chair

in its upright position.