Installation & Assembly

I. Place the backrest with legs (#1) on a
protected surface. Insert the wood
dowel (#F) into the center hole of the
backrest with legs (#1).
II. Align the seat (#2) with the wood dowel
(#F) and the pre-drilled holes of the
backrest with legs (#1).
III. Prepare 2 bolt assemblies by inserting
FIRST the lock washer (#B) onto the
bolt (#D) and then the flat washer (#A)
onto the SAME bolt (#D), in that order.
IV. Insert the bolt assemblies through the
holes of the seat (#2) near the wood
dowel (#F) and secure those bolts
using the Allen wrench (#E) to lock
them in with the backrest with legs
(#1).
V. Prepare 4 bolt assemblies by inserting
FIRST the lock washer (#B) onto the
bolt (#C) and then the flat washer (#A)
onto the SAME bolt (#C), in that order.
VI. Insert the bolt assemblies through the
pre-drilled holes in the corners of the
seat (#2) and secure those bolts using
the Allen wrench (#E) to lock them in
with the backrest with legs (#1).
Turn right (clockwise) to tighten
Page 4 of 5
#A x 6 pcs
#B x 6 pcs
#C x 4 pcs
#D x 2 pcs
#F x 1 pc
Insert the left leg support (#5) and the right leg support (#6) into
the pre-drilled holes of the backrest with legs (#1).
Note: Right and left are determined by standing in
FRONT of the chair in its upright position.