User's Manual

TIME.
FOR CLARITY.
FRAME ASSEMBLY
- SOME PARTS MAY HAVE BEEN REMOVED
NOTE:
- BEFORE ASSEMBLING (8) TO (7):
- REMOVE CAM GUARD PLATE (81) AND
CORRESPONDING HARDWARE.
- SHIFT
12.00" CAM (32) BACK SO (55)
CAN BE INSERTED TO COMPLETE (8)
TO (7) ASSEMBLY.
- REFER TO PAGE 9 FOR
12.00" CAM (32)
AND CAM GUARD PLATE (81) ASSEMBLY.
- WRENCH TIGHTEN HARDWARE.
- WRENCH TIGHTEN ALL PREVIOSULY HAND
TIGHTENED HARDWARE.
- WRENCH TIGHTEN HARDWARE (55) THEN
LOOSEN NUT JUST ENOUGH FOR (8) TO
PIVOT FREELY.
- INSTALL CABLE AND PULLEYS AT THE SAME
PAGE 07
OWNER'S MANUAL
RS-1102-A ASSEMBLY
84
*
7
59
83
55
59
83
61
66
31
64
61
61
64
8
26
57
61
59
63
61
56
47
59
57
61
23
9
U-BRACKET
JAM NUT
FINE TUNING:
64
PROPERLY INSTALLED VIEW
NOTE:
BE SURE BOLT (55) IS INSTALLED
SO BOLT HEAD FITS INTO
HEX BOLT LOCK, AS SHOWN.
*
BOLT IN/OUT TO GIVE THE CABLE
PROPER TENSION. RE-TIGHTEN
JAM NUT.
LOOSEN JAM NUT AND THREAD
WARNING - CABLE BOLT MUST BE THREADED
A MINIMUM OF 3/8" WITH JAM NUT TIGHTENED
SECURELY TO ENSURE PROPER CONNECTION.