rev 200-RM REV 200 Watt 2-Channel Amplifier F o r U s e O n Ru s h m o r e p l at f o r m b i k e s installation Manual
Thank you for choosing the Hogtunes REV 200-RM Amplifier for 2014+ Rushmore Platform Bikes. Since positive word of mouth is the best way to grow our business, we want your new system to work as well as it was designed to. If you have any questions or concerns, we are here to help. The REV 200-RM Amplifier is a Class D design. We chose this design because it yields plenty of power, is easy on the bike’s charging system and produces little heat.
installation instructions Step #1: Remove the seat and both wires (+ and -) from the battery. Remove the outer fairing/headlamp assembly and set aside. Refer to a service manual if you need help with this. NOTE: Placing a towel on the front fender can help prevent scratches or “dings” from dropped tools or fasteners, etc. Expletives will also be kept to a minimum! Step #2: Over top of the radio, pull up to release each wire harness from the black plate via the factory “Christmas Tree” fasteners.
Step #4: With the amplifier removed, sit the supplied silver plate on top of the radio as shown below. Put one of the supplied star washers on each factory screw and reinstall through the silver plate, through the factory black plate and into the top of the radio. Make sure that each screw has a star washer! Locate the main power harness and plug it into the matching “pig-tail” on the side of the amp. Locate the supplied input harness and plug into the “audio input” socket on the side of the amp.
Step #7: From the amp’s input connector, take the 2 pin plug with the green/ black wires and install it into the mating plug on the brake side of the bike. Also from amp’s input connector, take the 2 pin plug with the yellow/black wires and install it into the mating plug on the clutch side of the bike. NOTE: These are the plugs originally undone to allow the speaker cabinet to come out.
Adjusting Your System-Please Read! In order to make your new system perform as good as it was designed, please take a minute to understand and follow these tips: • Set your “Automatic Volume Control” (AVC) to 3 bars. After extensive on-road testing, we found that this AVC position works and sounds best. Your new amplifier has been specifically set-up for this radio setting. • Your Hogtunes system is designed specifically for a motorcycle at speed.
Warranty Information Please Record Your Amplifier’s Serial # Here_________________________ The REV 200-RM Amplifier is warranted for 3 years from original purchase date. Proof of purchase is required for all warranty claims. The warranty applies to the original retail customer and is not transferable. Please contact Hogtunes for all warranty claims. Products found to be defective during the warranty period will be repaired or replaced (with a product deemed to be equivalent) at Hogtunes sole discretion.
Hogtunes products will play much louder than the Original Equipment, which can be a distraction to the rider and/or passenger. Please use caution when adjusting or playing your stereo at high volume, especially in traffic. You are a valued customer so please: Ride Alert Arrive Alive! www.hogtunes.
