Installation Instructions

SECTION 1

1. Measure the door opening

If the height of the door opening is the same as the measurement of the

door, it won’t be necessary to cut the door height, if the opening is less; the

door (A) should be reduced by cutting off the excess in the bottom part of

the door panels. Place and attach the door panels together, use adhesive

tape if necessary and cut off the excess with a saw or handsaw. If the

opening is less than the door width, cut the Top track (B) 1/8” shorter than

the width of the opening.

2. Install the Top Track ( B)

Place the top track in the upper part of the door opening, so that it can be

straightened and centered. Mark the screw guides with a pencil, then

punch using a drill with a 3/32” bit. Place a 1” track screw through the screw

hole that is closer to the center of the Top track. Do not tighten it completely.

(Adhesive tape can be used to hold the Top track in place while marking

and drilling.

3. Install the handles (C)

By gently tapping introduce the two Handle pins (D) in the handle, then

insert the pins through the door track holes. Press the other handle (C)

against the handle pins. If necessary one of the handles can be supported

with a solid object to attach the other handle and tap gently on both sides

evenly inserting the pins until the handles are attached. Do not hit in the

center of any of the handles.

4. Install the upper sliders (I/J)

Place the upper slider T-style (I) on the hole of the main panel. In order to

affix the upper slider to the lead panel align the holes, then insert the

section of the female connectors (H) from the exterior part of the main

panel, going through the slider T-style (I) until it reaches the other side of

the guide border. Then insert the threaded male screw on the female side

and tighten it until it is adjusted. The sliders of the panels (J) must be

aligned and inserted in the panel hole.

Section 1